Informative day today as I peddled my rudder stock idea over at Mr. Storers forum.
There was enough persuasion action going to keep me going with the plans in term of a backless rudder stock with a daggerboard rudder. However, I really want to be able to ditch the tiller and leave the rudder installed on the transom.
I came up with this idea:
In this plan, the rudder stock stays exactly as the plans stipulate, except I add on 15mm at the top. This provides an area to attach a cleat (blue). Then theres another below it (blue) and the tiller-- which is two pieced-- cradles the rudder stock. Bolts run through the cleats into the spacer, and the tiller which slides between the cleats is held in place with a pin.
Storer warns that the torsional forces on the tiller could tear it apart, Im hoping that between the three cleats bolted through the spacer, and a bolt higher up on the tiller (not shown) to keep it together, I should be ok. Time will tell. I am almost positive this is the model Im going with, unless I get overwhelming evidence otherwise.
In other news, I finished rough shaping the rudder and daggerboard.
Nice.
0 comments:
Post a Comment