My second gunwale is scarfed and glued! As you can see, the epoxy will glue your bricks to the wood too! I had to chisel the brick off the wood, and it left brick behind which was further chiseled. This is my nicest, tightest scarf to date... on this side. Little more of a gap on the other side which is too bad, because the tight side will be glued to the boat due to a curvature in the wood that already nicely conforms to the hull.
My mast step and mast partner are glued up, in place, and ready to be cut open to fit the mast and then glued down. I doubled up the mast partner because the top of BH2 can be easily twisted by hand. By doubling it up, it stiffens it considerably. This makes me feel better after the chaotic gluing job around these bulkheads:
My bow knee came out well except for two things 1. I forgot that it was to be placed OVER the stem. My stem comes up to the edges of the ply, no room to slip it over. This means I will have to either slip it behind the stem or on top of it. I will ask Storer for recommendations. My bow was also considerably wider than the number provided by Storer for the knee. I would highly recommend tracing real world bow to your piece of lumber prior to cutting. Remember to keep the gunwales fastened. My stern knees, by comparison, came out great (I traced the real deal and did not go by the numbers provided by Storer). The great thing about my stern knees is that they are interchangeable, as in, both corners are the same! Yes! Precision building yes! Notice my mail. This is where I throw my bills. Then when I glue on the aft seat, they will be sealed in forever, and all my financial problems will disappear!
Because my workshop is a walk from my assembly point in the garage, my hull is becoming my new holding bin/workshop.
Its also dusty in there! My lonesome bike, covered in wood dust. Primarily this dust is from the wood cherry countertops being built by my brother in law right behind me, but the picture is cooler if everyone thinks its coming from my boat!
In addition,
1. my side arms for BH2 and 4 are cut and beveled to the sides (again, I waited until I got my boat assembled to match them to the actual hull)
2. inwale spacers are cut
I would like warmer temps in the garage before I start gluing things. As of right now, strictly hull, non-gluing, I need to do the following:
1. Cut out the mast holes in the partner and step
2. Scarf inwales
3. Finish fitting bow seat (waiting for gluing of seat cleats)
Other than that, rudder, daggerboard, mast and spars, centerboard trunk.
I am very close to having a totally completed hull.
0 comments:
Post a Comment