Framing the transom

Ooooh boy, Im in it now. I got home after being on the road for almost two weeks and immediately picked back up on working on the boat. I decided to frame the transom. I cut the cedar parts to frame the sides, the bottom, and the seat cleat in 2:45. I thought it would go significantly quicker, but it didnt because it was a little more complicated than I thought, and my framing was fraught with multiple mistakes. I also do not have a solid piece of cedar for the top piece, which needs to be wider than any of my stock. Maybe Ill use two pieces, maybe that will have to wait.

The first mistake was correcting an old one... the transom needs 7mm of extra on the sides of the ply and 12mm extra on the bottom. I figured this was extra that was going to be cut off, so I threw in a few extra mm to make round numbers. Turns out the 7 and 12 is important, because I will be basing the bevel of the sides and bottom off these numbers. Fortunately I read the section first before, cleaned up the lines to the correct length, and then cut and sanded smooth.

After that, it was a comedy of errors cutting the cedar to fit appropriately. In the end, it looks good, tight, and straight. Next up, I have to glue it all on and/or seal the ply in epoxy and then glue it on. I also do not know how to bevel any of this stuff. This is something I am going to have to ask about for because I dont know how to do it simply and without screw up. Time to phone the collective.